Subarray Commands
The following table contains information about the Mid CSP LMC commands of the subarray Tango device. A more extensive documentation about command parameters can be found in the Telescope Model - Mid.CSP schemas
Command name |
Description |
Parameters |
Example |
Sequence diagram |
Note |
---|---|---|---|---|---|
AssignResources |
Propagates the resources to be assigned to CBF
|
||||
Configure |
Propagates the configuration information to PST subsystem
Reads address information from PST
Add PST address information to CBF json string
Propagate the updated configuration information to CBF
|
||||
Scan |
Propagates the scanning information to subsystems
|
||||
ReleaseResources |
Releases the allocated resources defined in the input string
|
||||
ReleaseAllResources |
Releases all the allocated resources
|
No input |
|||
Gotoidle/End |
Moves CSP LMC and subsystems from obsState EMPTY to IDLE
|
No input |
|||
Endscan |
Interrupts a scan session
|
No input |
|||
Abort |
Interrupts the commands queue
Performs clean-up of command queues
Propagates the abort commadn to subsystems
|
No input |
|||
Off |
The Off command disables any signal processing capability of a device
|
List that contains the device FQDN. |
|||
Restart |
Recovers from a FAULT obsState. The subarray will be moved in EMPTY obsState
|
No input |
This command will release also all the resources, bringing the subarray into an EMPTY obsState. |
||
Reset |
Recovers from a FAULT State. The subarray will be moved in OFF/EMPTY state
|
No input |
The command is propagated to subarrays |