Controller Commands

The following table contains information about the Mid CSP LMC commands of the controller Tango device. A more extensive documentation about command parameters can be found in the Telescope Model - Mid.CSP schemas

Command name	Description	Parameters	Example	Sequence diagram	Note
On	The command has an argument list as input that contains the devices FQDN that have to be transition to ON.	List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices	On example	On diagram
Off	The Off command disables any signal processing capability of a device,	List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices	Off example	Off diagram
Standby	Transition the CSP to a low power consumption mode. The CSP LMC controller is responsible to propagate the transition to the subsystems	List that contains the devices FQDN. when the list is empty, the commmand is propagated to all the subsystem devices	Standby example	Standby diagram	Mid CBF does not support the command
loadDishCfg	This command inizializes the Mid.CBF system parameters	loadDishCfg input	loadDishCfg example	loadDishCfg diagram	If the command fails or is is not issued, the CBF cannot transition to On state
Reset	Recover from a FAULT State. The controller will be move in STANDBY obsState	No input	Reset example	Reset diagram	The command is propagated to subarrays