Subarray Commands

The following table contains information about the Low CSP LMC commands of the subarray Tango device. A more extensive documentation about command parameters can be found in the Telescope Model - Low.CSP schemas

Command name	Description	Parameters	Example	Sequence diagram	Note
AssignResources	Propagates the resources to be assigned to CBF	Assign resources with PST input Assign resources without PST input	Assign resources without PST example	Assign resources diagram	CBF uses this command only for transitioning obstate IDLE
Configure	- Propagates the configuration information to PST subsystem - Reads address information from PST - Add PST address information to CBF json string - Propagate the updated configuration information to CBF	Configure with PST input Configure without PST input	Configure example	Configure diagram
Scan	Propagates the scanning information to subsystems	Scan input	Scan example	Scan diagram
ReleaseResources	Releases the allocated resources defined in the input string	Release resources input	Release resources example
ReleaseAllResources	Releases all the allocated resources	No input	Release resources example
Gotoidle/End	Moves CSP LMC and subsystems from obsState EMPTY to IDLE	No input	Go to idle example
Endscan	Interrupts a scan session	No input	EndScan example	EndScan diagram
Abort	interrupts the commands queue performs clean-up of command queues propagates the abort commadn to subsystems	No input	Abort example	Abort diagram
Off	The Off command disables any signal processing capability of a device	List that contains the device FQDN.	Off example	Off diagram
Restart	Recovers from a FAULT obsState. The subarray will be moved in EMPTY obsState	No input	Restart example	Restart diagram	This command will release also all the resources, bringing the subarray into an EMPTY obsState.
Reset	Recovers from a FAULT State. The subarray will be moved in OFF/EMPTY state	No input	Reset example	Reset diagram	The command is propagated to subarrays